Lab configuration
Posted: Fri Nov 18, 2016 1:39 am
Hi there
It seems my lab coordinate system does not conform to the standard. Y is the direction of motion, Z is the vertical axis, but then by the right hand rule X is the negative direction. Will this present a problem? Do I then rotate my force plates so that the relate to my actual lab configuration, or so that they conform to the lab coordinates with the x axis switched around?
Thank you
It seems my lab coordinate system does not conform to the standard. Y is the direction of motion, Z is the vertical axis, but then by the right hand rule X is the negative direction. Will this present a problem? Do I then rotate my force plates so that the relate to my actual lab configuration, or so that they conform to the lab coordinates with the x axis switched around?
- LabConfig.JPG (76.81 KiB) Viewed 502 times