Help request CMC

Provide easy-to-use, extensible software for modeling, simulating, controlling, and analyzing the neuromusculoskeletal system.
POST REPLY
User avatar
Ana Castro
Posts: 1
Joined: Sun Dec 07, 2014 9:08 am

Help request CMC

Post by Ana Castro » Thu Jun 18, 2015 8:32 am

Recently I have been having some problems with the CMC tool and I would like to ask for your help. In this topic I attached a screen shot with the set up that I use (2) and another with the error message (that sometimes appears in the beginning of the process and other times just appears in the middle, when the percentual counting is already activated). Hope that you can help me.
Screenshot_CMCtool_Setup_1.png
Screenshot 1 - Setup CMC 1
Screenshot_CMCtool_Setup_2.png
Screenshot 2 - Setup CMC 2
Screenshot_CMCerrormessage.png
Screenshot 3 - CMC error message
Thank you so much.
Best regards,
Ana Lúcia Castro
Top
User avatar
Emil Walczak
Posts: 50
Joined: Fri Feb 06, 2015 6:45 am

Re: Help request CMC

Post by Emil Walczak » Thu Jun 18, 2015 9:08 am

Propably muscles are to weak, you have tried to increase the constraints value for residual actuators in constraint .xml file?
Top
User avatar
Mahdi Hassan
Posts: 7
Joined: Mon Sep 23, 2013 8:10 pm

Re: Help request CMC

Post by Mahdi Hassan » Fri Jun 19, 2015 3:04 pm

Please check the degree of freedom. You may lock some degree of freedom which are necessary for the simulation.

Thanks
Hassan
Top
POST REPLY