When meshing, my only working tool is surface meshing. As I know that I also need Volume Meshing to run a successful simulation, I would appreciate your help.
I have adjusted the segmentations to be as perfect as possible. There are no overlapping sections or holes in it. I did remesh the ends. I have gone through much of the software, investigating where I could be going wrong, without avail.
Thank you for your time
Matt M
Volume Meshing Will Not Work
- David Parker
- Posts: 1677
- Joined: Tue Aug 23, 2005 2:43 pm
Re: Volume Meshing Will Not Work
Hi Matt,
If you upload your model someplace I can download it I'll have a look.
Cheers,
Dave
If you upload your model someplace I can download it I'll have a look.
Cheers,
Dave
- Matthew Monaghan
- Posts: 7
- Joined: Fri Jul 10, 2020 11:51 am
Re: Volume Meshing Will Not Work
I just emailed it to you. Thanks!
- David Parker
- Posts: 1677
- Joined: Tue Aug 23, 2005 2:43 pm
Re: Volume Meshing Will Not Work
The problem was from intersecting segmentation contours producing a self-intersecting surface. Models must have well-defined surfaces (no holes, non-intersecting) in order to mesh.
Cheers,
Dave
Cheers,
Dave
- Attachments
-
- Screen Shot 2020-07-22 at 3.39.29 PM.png (68.34 KiB) Viewed 72 times
-
- Screen Shot 2020-07-22 at 3.35.24 PM.png (142.8 KiB) Viewed 72 times