Dear developer,
I want to create an aneurysm model with thrombosis. I found it difficult to draw cross sections without thrombosis along the center-line. Do you have a better way to do this? I attached a draft to show what the aneurysm looked like.
Thank you very much. -v-
Model subtraction
- David Parker
- Posts: 1677
- Joined: Tue Aug 23, 2005 2:43 pm
Re: Model subtraction
Hello Dai,
I'm not entirely clear about what you want to do. Do want to create a cross-section excluding the thrombosis? If so then you can create a cross-section using the SplinePolygon segmentation.
Cheers,
Dave
I'm not entirely clear about what you want to do. Do want to create a cross-section excluding the thrombosis? If so then you can create a cross-section using the SplinePolygon segmentation.
Cheers,
Dave
- Attachments
-
- Screen Shot 2020-08-26 at 11.42.39 AM.png (65.57 KiB) Viewed 339 times
- Dai Xiao Dai
- Posts: 54
- Joined: Thu Jan 04, 2018 12:49 am
Re: Model subtraction
Hello Dave,
I can draw a part of the model in your way. But please look at this figure. It seemed that the thrombosis did not touch the wall. Along the centerline, I need to draw something like a ring (the green part). I don't know what to do.
Cheers,
Dai
I can draw a part of the model in your way. But please look at this figure. It seemed that the thrombosis did not touch the wall. Along the centerline, I need to draw something like a ring (the green part). I don't know what to do.
Cheers,
Dai
- Attachments
-
- fig.png (59.22 KiB) Viewed 316 times
- David Parker
- Posts: 1677
- Joined: Tue Aug 23, 2005 2:43 pm
Re: Model subtraction
Hello Dai,
I don't quite understand what you are saying. You need to outline the vessel wall and the thrombosis. You may have to create an artificial path to do this, just something that allows you to outline the thrombosis.
We are working on integrating some 3D segmentation tools that will make this process easier.
Cheers,
Dave
I don't quite understand what you are saying. You need to outline the vessel wall and the thrombosis. You may have to create an artificial path to do this, just something that allows you to outline the thrombosis.
We are working on integrating some 3D segmentation tools that will make this process easier.
Cheers,
Dave