I intend to estimate knee joint contact loads using the Muscle forces estimated through CEINMS toolbox. The muscles forces estimated are similar to ones reported in literature for STS transfer.
Also, since, JRA is highly sensitive to inputs, I validated my IK & ID results with the literature. The errors for scaling and IK were within the recommended limits as suggested in Opensim best practices.
I was initially using a modified version of 2354 model with 6 D0F in knee joint. However, switched to Rajagopal model since its more suitable for muscle-driven simulations and also has more muscles in lower extremity. I disabled the torque actuators of upper body when doing JRA since it showed not enough actuators message earlier.
The results from JRA tool (in child frame as well as ground ) show overestimated loads as compared to in vivo data which is under 3 times the Body Weight for both models.
The results from Rajagopal model are
- image.png (77.25 KiB) Viewed 408 times
Are there any suggestions/recommendations which I need to consider to solve this problem.
Any help will be highly appreciated.
Thank you
Best regards
Zakia