Is it possible to apply flow rate and pressure as boundary conditions to a single face?

Provides a system for patient-specific cardiovascular modeling and simulation.
POST REPLY
User avatar
Ryo shimodoumae
Posts: 6
Joined: Mon Jun 27, 2022 12:03 am

Is it possible to apply flow rate and pressure as boundary conditions to a single face?

Post by Ryo shimodoumae » Mon Oct 21, 2024 1:08 am

Hello,
I am performing FSI using the svFSIplus solver.
I would like to set two boundary conditions for one surface. Is this possible?
The boundary conditions I would like to set are the time-distributed flow rate waveform and pressure waveform.

Thank you in advance.
Ryo
Top
User avatar
David Parker
Posts: 1747
Joined: Tue Aug 23, 2005 2:43 pm

Re: Is it possible to apply flow rate and pressure as boundary conditions to a single face?

Post by David Parker » Mon Oct 21, 2024 10:20 am

Hi Ryo,

You can't specify both a pressure and a velocity boundary condition on the same surface since they are coupled.

Cheers,
Dave
Top
POST REPLY