Yes, Thanks Ayman,
There were blanks instead of zeros in the data file--this can be seen by comparing my data to good data in excel.
I replaced blanks with zeros with the attached matlab script and now the forces look good.
Cheers,
John
Could not associate motion to current model
- John Rogers
- Posts: 45
- Joined: Fri Feb 24, 2012 11:47 am
- John Rogers
- Posts: 45
- Joined: Fri Feb 24, 2012 11:47 am
Re: Could not associate motion to current model
Thanks again.
Here is the matlab file I used to pad with zeros. Cheers,
John
Here is the matlab file I used to pad with zeros. Cheers,
John
- Ayman Habib
- Posts: 2248
- Joined: Fri Apr 01, 2005 12:24 pm
Re: Could not associate motion to current model
Great, thanks for sharing John.
Cheers,
-Ayman
Cheers,
-Ayman