Hi,
I'm having trouble getting my program to simulate all the way through. I've tried decreasing the amount of precision and number of points where information is recorded however the program stops working less than a quarter of the way through. I was wondering if there was any other way to increase the amount of time the program runs for?
Thanks
Trouble Getting program to run all the way thorugh
- Brianna Goodwin
- Posts: 3
- Joined: Sat Oct 19, 2013 12:11 pm
- Ayman Habib
- Posts: 2236
- Joined: Fri Apr 01, 2005 12:24 pm
Re: Trouble Getting program to run all the way thorugh
Hi Brianna,
Can you please provide more details on what are these program(s) that you're running, on what platforms, and using what versions of the software. It's a bit hard to help you without such details. Different tools can terminate for different conditions, but usually there's a log/output file indicating why it stopped.
Thanks,
-Ayman
Can you please provide more details on what are these program(s) that you're running, on what platforms, and using what versions of the software. It's a bit hard to help you without such details. Different tools can terminate for different conditions, but usually there's a log/output file indicating why it stopped.
Thanks,
-Ayman
- Brianna Goodwin
- Posts: 3
- Joined: Sat Oct 19, 2013 12:11 pm
Re: Trouble Getting program to run all the way thorugh
Hi Ayman,
The program is set to run for 3 seconds however whenever I try to run it, it quits and only gives results up to 0.305 sec or freezes and doesn't continue. I'm using Windows 7, and OpenSim 3.1. Where can I find the log/output file to determine why it stopped?
Thanks for your help!
Brianna
The program is set to run for 3 seconds however whenever I try to run it, it quits and only gives results up to 0.305 sec or freezes and doesn't continue. I'm using Windows 7, and OpenSim 3.1. Where can I find the log/output file to determine why it stopped?
Thanks for your help!
Brianna