SCONE error

[Samane Amini]

Hello guys

I would like to open the WeaknessSOLMild.scone from the paper" Predicting gait adaptations due to ankle plantarflexor muscle weakness and contracture using physics-based musculoskeletal simulations" . But the this error is been made. Would you please guide me how to fix it?

OpenSimModel:
GaitStateController:
ReflexController:
Error parsing parameter 'S00011.glut_max.L0': mean is outside range

Captureww.PNG (12.73 KiB) Viewed 490 times

[Thomas Geijtenbeek]

Hi Samane, where did you obtain the .scone file from? I can have a look and see if I can fix it.

[Samane Amini]

Hey Thomas

Thank you for your replying

I have obtained it from the following link:

https://simtk.org/frs/?group_id=1631

Best

[Carmichael Ong]

The issue came up because of some of the default values in the file 'scone-setup-files/import/GaitController.scone'.

Code: Select all

						
Reflex {
	type = MuscleReflex
	target = glut_max
	delay = 0.005
	KL {
		init_mean = 0.5
		init_std = 0.2
		min = 0.0
		max = 10.0
	}
	L0 {
		init_mean = 1.2
		init_std = 0.1
		min = 0.5
		max = 1.1
	}
	KV {
		init_mean = 0.2
		init_std = 0.2
		min = 0.0
		max = 10.0
	}

For L0, the 'init_mean' parameter is out of bounds of the 'min' and 'max' values. Updating that parameter to be valid will likely fix the issue.

Note that these files aren't tested on newer versions of SCONE. My guess is that there was a change to when the mean value is checked against the min and max values. The .par file that is used as the 'init_file' has a L0 value for glut_max that is within bounds. So, there may be other instances of this issue that will have to be fixed to use these files with a newer version of SCONE.

[Samane Amini]

Hey Carmichael

Thank you for your replying.

Do you think which SCONE version will work on it?

Best

[Samane Amini]

Hi again

I have installed scone version 1.0. it works. However, giving a scenario has made an error:

Would you please how to correct it?

Capturesss.PNG (16.55 KiB) Viewed 430 times

[Thomas Geijtenbeek]

Please note that this issue has been resolved. You can download the updated files form the project page.