Predicting GRF

Provide easy-to-use, extensible software for modeling, simulating, controlling, and analyzing the neuromusculoskeletal system.
POST REPLY
User avatar
Mohammadreza Rezaie
Posts: 408
Joined: Fri Nov 24, 2017 12:48 am

Predicting GRF

Post by Mohammadreza Rezaie » Sun May 17, 2020 6:56 am

Hi,

I'm quite interested in learning the ways of predicting the Ground Reaction Forces in OpenSim.

Any help is much appreciated.

Tags:

User avatar
Michael Asmussen
Posts: 67
Joined: Mon Jul 11, 2016 7:46 am

Re: Predicting GRF

Post by Michael Asmussen » Tue May 19, 2020 11:24 am

Dear Mohammad,

Check out this project: https://simtk.org/projects/contact_osim_u

It provides a good introduction to contact modelling that might help you with your project.

All the best,

Mike

User avatar
Mohammadreza Rezaie
Posts: 408
Joined: Fri Nov 24, 2017 12:48 am

Re: Predicting GRF

Post by Mohammadreza Rezaie » Wed May 20, 2020 2:19 am

Dear Michael,

Many thanks for your reply. They are very helpful and I appreciate it.

I was looking for something like this in OpenSim v. 4.x:
https://opensim.stanford.edu/support/ev ... .php?id=37

Is there any workaround for that?
(I mean using markers and IAA instead of defining contact points)

Your response would be greatly appreciated.
Kindly Regards

User avatar
Michael Asmussen
Posts: 67
Joined: Mon Jul 11, 2016 7:46 am

Re: Predicting GRF

Post by Michael Asmussen » Thu May 28, 2020 9:26 am

Dear Mohammad,

I am not an expert in IAA, but based on the link your provided, it appears that some sort of contact modelling is implemented.

I don't know what your research question is, but you may benefit from checking out this project and the publications associated with it: https://simtk.org/projects/datatracking

I hope that helps!

Mike

User avatar
Markus Kurz
Posts: 9
Joined: Mon Jun 01, 2020 10:37 am

Re: Predicting GRF

Post by Markus Kurz » Sat Jul 18, 2020 7:11 am

Dear Michael,

Thanks for the Link you provided about the contact modeling.
I downloaded it but having difficulties opening it because I am getting following error within the GUI
error.JPG
error.JPG (44.27 KiB) Viewed 421 times
Maybe you can help me with that, that would be perfect.

Kind regards,
Markus

POST REPLY